Wall Mount - Wolf 812307 Manual De Instrucciones

waLL MOUnT

For use with Models ICBPW3048, ICBPW3648, ICBPW448, ICBPW4848, ICBPW5448,
ICBPW3078, ICBPW3678, ICBPW478, ICBPW4878, ICBPW5478, ICBPL34,
ICBPL46, ICBPL5, ICBDD30R,
ICBDD36R, ICBDD45R
prepare the wall
24¾"
10¾"
8½"
12 / "
7
8
Pilot Pilot
Hole Hole
1¼"
dia. hole
OUTSIDE - WALL VIEW
From inside the wall:
1
Drill a PiLOT HOLE through the wall, 8½" from the inside
edge of a waLL STUD.
From outside - on the wall:
2
Measure and mark the 25" x 29½" rectangle. Cut and
remove only the siding inside this rectangle.
3
Measure and mark the 11" DiaMETEr HOLE and the 1¼"
DiaMETEr HOLE. Cut these holes all the way through the
wall.
inSTaLLaTiOn
REMOVE
SIDING
11" dia.
hole
9 1 / "
8
7¼"
install the Ventilator
4
Remove 7 COVEr SCrEwS and lift off ventilator cover.
5
Remove and discard SHiPPing CarDBOarD from blower
wheel.
6
Feed the electric power cable (supplied with ventilator)
through the 1¼" DiaMETEr HOLE in wall.
7
Position ventilator on wall so its discharge collar fits into 11"
diameter hole.
8
Use 6 screws (provided) to attach ventilator to wall. 6
MOUnTing HOLES are provided.
9
Seal screw heads and edges of flashing sheet with a good
grade of roofing cement or other sealant.
10
Check for free movement of spring-loaded damper and
re-install ventilator cover.
28¼"
7 Cover 7 Cover
Screws Screws
attach power cords to hood
11
The ventilator is prewired with 12 feet of H05VV-F
3G1 power cable. Run ventilator cable to range hood's
electrical wiring box.
12
Secure cable to range hood with a strain relief (included
in parts bag). Make wiring connections per instructions
provided with your Wolf range hood.
13
Install the separate power cord and strain relief (included
in parts bag) to the range hood. Refer to instructions
provided with your Wolf range hood.
14
Turn on power and check for proper operation of
ventilator.
MODEL 812307
Shipping
Cardboard
Wiring
Cover
Bird Screen
Flashing Sheet
OUTSIDE - WALL VIEW
Page 3
6
Mounting
Holes