NuTone 665RP Guia De Inicio Rapido página 3

4. Use a flat-bladed
screwdriver
to remove the
proper electrical
knockouts.
Installation work and electrical wiring must be done by a quali-
fied person(s) in accordance with all applicable codes and stan-
dards, including fire-rated construction codes and standards.
5. Connect
electrical
wiring as
shown.
HEAT
A
BLUE
BLACK
2 WHITE
WIRES
RED
HEAT
VENT
LIGHT
BLACK
3 GROUND
WIRES
C
VENT
B
C
A
3 WHITE WIRES
RED
BLACK
3 GROUND WIRES
3 WHITE WIRES
120 VAC LINE IN
WIRE OPENING
If the switch has not been wired properly and wires need to
be moved:
1. Each wire opening has a release slot.
2. Push a small nail or screwdriver into release slot while
gently removing wire. 3. DO NOT pull any wire out of the switch without using
the release slot. The switch may be damaged.
6. Replace the fan assembly removed in Step 4, under "PRE-
PARE THE UNIT" on Page 2. Plug fan assembly into recep-
tacle (C) on the the side of the wiring cover. Direct wires away
from blower inlets.
7. Replace the heater assembly removed in Steps 2, 3, under
"PREPARE THE UNIT" on Page 2. Plug heater assembly into
receptacle (A). Direct wires away from blower inlets.
8. Install grille and
light reflector.
LIGHT
Plug light into
B
receptacle (B).
Tighten acorn
nut securely.
Be careful not
to overtighten
nut and deform
reflector.
Install a 100 Watt
(maximum) light
bulb.
9. Install light
lens. Gently
squeeze tabs
on lens and
insert them
into the slots
in the grille.
MODEL 665RP
Page 3
RELEASE SLOT