Clatronic PM 3635 Instrucciones De Servicio página 25

Before using the first time
The following instructions need to be followed only when using
the appliance for the first time after removing it from the packing:
• Clean the appliance and accessories as described under
"Cleaning".
• Place the appliance on a non-slip and level surface.
• Place the transparent lid on the appliance.
• Insert the measuring beaker in the opening in the top of the
transparent lid.
• Insert the plug into a duly installed protective contact socket
and switch on the appliance. Make it work for about 3 min-
utes without any ingredients in it to eliminate any impurities
that may be present in the appliance!
• Then leave the appliance to cool for 15 minutes! The appli-
ance is now ready for use!
Use
1. Turn off the appliance (switch position: O).
2. Fill the beaker the popcorn. This is equal to the maximum
amount of approx. 70 g.
3. Take the transparent lid off the appliance and pour in the
contents of the beaker through the popping slot.
4. Fit the transparent lid back on the appliance and insert the
measuring beaker in the opening in the top of the lid.
CAUTION:
• If you wish to add salt or butter to your popcorn, do
so once the popcorn is ready and has been removed
from the appliance!
WARNING:
• Always remove the mains lead before cleaning!
• Wait until the machine has cooled down completely!
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Wash the transparent lid and the measuring beaker in a
normal sink.
CAUTION:
• Do you want to melt the butter while preparing pop-
corn? – You may insert the measuring cup including
the butter into the cover, observing the following: Do
not overfill the measuring cup! Otherwise there is a
risk that the butter flows into the appliance at a later
point. Fill the cup with a maximum of 30 g of butter
(room temperature).
5. Place a heat-resistant bowl with a capacity of 3-4 liters
under the opening in the transparent lid.
6. Insert the plug into a duly installed protective contact socket
and switch on the appliance with the ON/OFF button (switch
position: I).
NOTE:
The popping procedure starts after about 1 min.: the corn
pops and falls out of the opening in the lid into the bowl.
7. When you start to hear only occasional "pops", switch the
appliance off.
NOTE:
Usually 10 to 20 kernels remain in the appliance without
popping.
8. If you wish to make another portion, remove the remaining
kernels of corn from the appliance. Leave the appliance to
cool down at least for 15 minutes between the cooking of
two consecutive portions!
Stopping Operation
Switch off the appliance after use with the ON/OFF button and
pull out the plug.
Cleaning
• Clean the main part of the appliance with a slightly moist
cloth without any detergents!
• Dry the appliance well before using it again or putting it
away after cleaning.
25