Analysis And Problems Solving; Problem, Causes And Solutions; Maintenance - Skymsen ABSC Manual De Instrucciones

5. Analysis and Problems Solving

5.1 Problem, causes and solutions

The equipment has been designed to operate with the need of minimum maintenance but
the natural wearing caused by longer use of the equipment may occasionally cause some
malfunctions.
If such problem occurs with your equipment, refer to Table 02 in which the most common
situations are listed with recommended solutions.

6. Maintenance

Maintenance should be considered a set of procedures aimed at keeping equipment in top
operating conditions, providing greater longevity and security.
* Cleaning - Cleaning Check item 3.3 of this manual.
* Wiring - Check all cables for impairment and all contacts (terminals) Electric for tightness
and corrosion.
* Contacts - On / off switch, emergency button, reset button, electronics, etc. Check the
equipment so that all components are working properly and that the device operation is
normal.
* Installation - Check the installation of your equipment as per item 2.1 Installation of this
manual.
* Product Lifecycle - 2 years, for a normal shift.
1 - Items to check and perform monthly:
- Check the electrical installation;
- Measure the mains voltage;
- Measure the operating current and compare with the nominal;
- Check tightness of all electrical terminals of the device to avoid possible bad contacts;
- Check any slack of the electric motor shaft;
- Check the wiring and electrical cables for signs of overheating, poor insulation or
mechanical breakdown.
2 - Check Items and run every 3 months:
- Check electrical components such as on / off switch, emergency button, reset button and
electronic circuit as the signs of overheating, poor insulation or mechanical breakdown.
- Check any slack in the bearings and bearings.
- Check seals, o-rings, v'rings rings and other seals systems.
20