Teka HPS-635 Guía De Uso página 26

3172754-000 EPIFA 29/05/14 12:25 Página 26
PROGRAMMING AND OPERATING THE PYROLYTIC FUNCTION
Follow the instructions below to carry out a
pyrolytic cleaning cycle:
1 IMPORTANT: Remove all accessories
(shelves, grids, side supports to hold up
the shelves, telescopic guide rails) from
inside the oven.
2 Turn the cooking control dial to Pyrolysis
position .
3 After a few seconds, P2 (pyrolysis program-
me 2) will appear on the timer display, the
symbol will also remain lit up.
4 You can now change the pyrolysis program-
me to P1, P2 or P3 by pressing the
keys:
P1: Minimum programme. Duration 1 hour
P2: Standard programme. Duration 1 hour
and 30 minutes
P3: Maximum programme. Duration 2
hours
5 You will hear 2 consecutive beeps after
several seconds or by pressing the
confirming the chosen programme.
6 After a short time, you will see the time
remaining for the selected programme to
end and the symbol
display. The pilot light
the oven door cannot be opened, as the
heating will have begun.
IMPORTANT: At this point, the oven is pro-
grammed and the pyrolytic cleaning cycle is
underway. During the cycle, none of the timer
functions can be selected, except the child
lock. Do not try to open the oven door as it may
interrupt the cleaning process.
7 When the pyrolytic cleaning cycle has finis-
hed, an alarm will sound, the symbol
will flash and you will see the correct time
on the display.
8 Press any of the timer's keys to disable the
alarm.
26
9 Set the cooking control dial to position
10 The oven's heating process has ended,
IMPORTANT
The cooling process may last up to 2 hours
owing to the high temperatures inside the
oven.
11 Once the oven has cooled down, pilot light
or
12 Press the
IMPORTANT
To open the door (pilot light
dial must be in position
instruction 9 set the control dial to position
and wait a few minutes until the door unlocks
and the pilot light switches off.
key
13 Open the oven door and wipe the inside
lit up on the timer
will turn on and
14 Once the oven is clean, do not forget to
15 The oven is now ready to be used.
IMPORTANT: If any incidents are detected in
the programming and operating of this func-
tion, consult the section "Incidents while
Operating the Pyrolytic Function".
however the oven is extremely hot and can-
not be used. The cooling motor will opera-
te until the oven cools down, pilot light
will remain on and the symbol
flash on the timer display.
will automatically turn off.
key to stop symbol 9 flas-
hing.
. If you did not follow
with a damp cloth, cleaning up the ash
from the cleaning cycle. Areas in the oven
that are difficult to access will need to be
cleaned with a non-metallic fibre scourer.
replace the supports and accessories.
.
will
on), the control