Stihl FCS-KM Manual De Instrucciones página 7

THE POWER TOOL (KOMBIENGINE
EQUIPPED WITH EDGER
KOMBITOOL)
For illustrations and definitions of the
power tool parts see the chapter on
"Main Parts."
WARNING
Never modify this power tool in any way.
Only attachments supplied by STIHL
and expressly approved by STIHL for
use with the specific STIHL
KombiEngine are authorized. Although
certain unauthorized attachments are
useable with STIHL power tools, their
use may, in fact, be extremely
dangerous.
If this tool is subjected to unusually high
loads for which it was not designed (e.g.
heavy impact or a fall), always check
that it is in good condition before
continuing work. Check in particular that
the controls and safety devices are
working properly. Do not continue
operating this machine if it is damaged.
In case of doubt, have it checked by your
STIHL servicing dealer.
THE USE OF THE POWER TOOL
(KOMBIENGINE EQUIPPED WITH
EDGER KOMBITOOL)
Transporting the Power Tool
WARNING
To reduce the risk of injury from loss of
control and blade contact, never carry or
transport your power tool with the cutting
attachment moving.
FCS-KM
WARNING
Always switch off the engine and make
sure the cutting blade has stopped
before putting a power tool down.
It may be carried only in a horizontal
position. Grip the shaft in a manner that
the machine is balanced horizontally.
Keep the hot muffler away from your
body and the cutting attachment behind
you.
WARNING
When transporting it in a vehicle,
properly secure it to prevent turnover,
fuel spillage and damage to the unit.
Before Starting
WARNING
Always check your power tool for proper
condition and operation before starting.
Never attempt to modify the controls or
safety devices.
WARNING
Never operate your power tool if it is
damaged, improperly adjusted or
maintained, or not completely or
securely assembled.
WARNING
Do not attach any cutting attachment to
a unit without proper installation of all
required parts. Failure to use the proper
parts may cause the blade to fly off and
seriously injure the operator or
bystanders.
WARNING
The cutting attachment must be properly
tightened and in safe operating
condition. Inspect for loose parts (nuts,
screws, etc.) and for cracked, bent,
warped or damaged blades. Replace
damaged blades before using the power
tool.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, fuel mix,
grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
WARNING
To reduce the risk
of personal injury
to the operator
from blade con -
tact and thrown
objects, make sure
your unit is
equipped with the
proper deflector,
handle and har -
ness (if
applicable).
An arrow on the deflector shows the
correct direction of rotation of the cutting
blade.
English
5