Selecting Channels - Graco Ultraclear 2755 Manual Del Propietário

Using AC Adapters
• The Parent's Unit can use either a 9 volt battery or standard 120 volt AC household current.
The Nursery Unit uses standard 120 volt AC household current only. The included AC
adapters must be used for this purpose.
• To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of
the unit. Then plug adapter into a standard wall outlet.
• Use ONLY the Graco adapters included with the unit. Do not use these adapters with
other equipment under any circumstances.
• If units do not work, check that AC adapters are plugged into working outlets.
• When electricity is off (from a power failure, etc.), the transmitter will NOT work, since it only
operates on AC current.

Selecting Channels

• Check that both Nursery Unit and Parent's Unit are set to the same channel.
• To change channel, slide Channel button to either A or B on BOTH units.
Setting Up the Baby Monitor
1. Check that both Nursery Unit and Parent's Unit are set to the same channel.
2. Place the Nursery Unit within 10 feet (2-3 meters) of your baby. Plug an AC adapter into the
jack on the side of the Nursery Unit. Plug it into a working 120 volt AC outlet.
3. Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that
could block sound transmission.
4. Turn on the Nursery Unit using the ON/OFF switch. The green power light should come on.
5. Install a 9 volt battery into the Parent's Unit, or plug it into a working 120 volt AC outlet using
the other AC adapter.
6. Turn on the Parent's Unit using the volume control dial. The red power light should come on.
7