Tabla de contenido
Idiomas disponibles
Idiomas disponibles
How To Install
Getting Started
STEP 1: IDENTIFY GATE PLACEMENT
For maximum security, DO NOT use this gate in any location without installing all
4 wall cups, sticky pads and screws provided. In some openings only 2 top wall cups
can be fi tted. The gate must be installed between two structurally sound surfaces.
GATE IS SUITABLE FOR:
TOP OF STAIRS
If installing the gate at the top of stairs, it MUST be
placed on the top landing and only swing away from
the stair.
BOTTOM OF STAIRS
If installing the gate at the bottom of stairs, we
recommend placing it on the fl oor. If the gate must
be placed on the lowest stair, position it toward the
front of the step.
HALLWAYS AND DOORWAYS
Be sure that the gate is resting on the fl oor.
The gate should NOT be raised above the fl oor.
6
STEP 2: VERIFY PROPER WIDTH
Measure the width of the opening where the gate will be installed. Be sure to measure
at the narrowest point between the walls. For example, include any baseboards in your
measurement. Then, see below for the proper gate confi guration for your opening.
TOOLS NEEDED:
• Tape measure
33"–35" (83.8CM–88.9CM)
Skip to page 9.
29.5"–32.5" (75CM–82.5CM)
Proceed to page 8.
PLEASE NOTE: See page 15 for additional
extension confi gurations.
How To Install
Remove 1 small extension
7
Tabla de contenido
