Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Setup / usage:
1
Fill with clean tap water. Do not exceed water level shown.
SKIN BuRN HAzARd. Water container must
rest on a sturdy, level surface and in upright
position.
Filling the steamer with hot water will greatly reduce the
time to produce steam. A full container will operate for
about 70 minutes.
2
Line up notch in hose receptacle (a) with the guide on the
hose (b). Insert hose and turn clockwise approximately
130º. Hand-tighten locking nut. do Not cross-thread
the locking nut.
Connect other end of hose to the steam plate. Hand-
tighten fitting onto plate.
3
Connect matching end of cord to the steamer. Plug in the
power cord.
Make sure steamer is placed on a sturdy,
level surface.
Once the power cord is plugged in, it will take about 12-15
minutes to produce steam. do Not leave steam plate
unattended, or face down on any surfaces.
4
For best results, use a scoring tool or a putty knife and
gently score the wallpaper in a crisscross pattern. The
perforations will allow the steam to penetrate the wallpaper.
Once steam is flowing out of the steam plate, hold the
steam plate flat against the scored wallpaper for about
10 seconds. Move the steam plate to a new section and
remove the steamed section with the scraper blade.
5
do Not operate the steamer once the water container
is empty.
To refill, unplug power cord and let steamer cool for 2
minutes. SLoWLy remove steam hose and refill the
container. Replace hose, plug in power cord and allow
unit to reheat.
Storage :
1
Unplug the steamer from the power source.
Wait a minimum of 2 minutes and slowly open the hose
connection.
Drain remaining water from the container. NeveR store
the unit with water in the container.
(a)
(b)
3
Max
Max
Make sure to wear
gloves and eye
protection.
English
Tabla de contenido
