How To Assemble The Light Kit - Fanimation The Xeno FP6728 Serie Manual Del Propietário

Ventilador de techo

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

CAUTION

To Reduce The Risk Of Electric Shock, Disconnect

The Electrical Supply Circuit To The Fan Before

Installing Light Kit.

1. Remove one of the three screws in the support

bracket at the bottom of the motor assembly and

retain the screw for later. Slightly loosen the

remaining two screws. (Figure 1)

2. Assemble the light plage assembly to the motor

assembly support bracket using the two key slots

in the light plate assembly. Replace the previously

removed screw and securely tighten all three screws.

(Figure 2)

3. Remove one of the three screws in the light

plate assembly and retain the screw for later.

Slightly loosen the remaining two screws. (Figure 3)

4. Connect the 2 single-pin connectors from the

LED assembly to the 2 single-pin connectors from

motor assembly. (Figure 4 )

CAUTION

The light source is designed for this specific

application and can overheat if serviced by untrained

personnel. If any servicing is required, the product

should be returned to an authorized service facility

for examination or repair.

5. Assemble the LED assembly to the light plate

assembly using the two key slots and replace the

third screw and securely tighten all three screws.

(Figure 5 )