Idiomas disponibles
Idiomas disponibles
USE
1. Boiling water function
Open the lid and full water (not more than the maximum water level 1. 8 L and cannot be less
than minimum water level 0. 8 L), then put on the lid.
Connected the power, the pot body into the power base. Now nothing appear in LCD, which
means the kettle is on standby. When the kettle on standby, only can use the 'I/O', you can use
'+' and '-' buttons.
Method 1: firstly, press '+' or '-', LCD show 40℃. Press '+' or '-' again, choose to set
temperature of the boiling water , and then press 'I/O', LCD flashing constantly means boiling
water ;If don't press 'I/O' , LCD will not flicker, after 10 seconds , LCD no display, the kettle back
to standby.
Method 2: firstly press the' + 'or' - 'button and select the temperature of the boiling water (if only
press 'I/O', by default water will be boiled up to 100℃.
LCD show s '100', LCD will keep flashing, into boiling water. When Set the boiling water for
100 ℃, the water must be 100 ℃.
In the process of boiling water, press '+' or '-', you can reset the temperature. When set
temperature is higher than the actual water temperature, continue to boil water; When the actual
water temperature is up to the set temperature, the heating tube will not work, and electronic
board start the time, about 2 minutes later, LED no display, which means the kettle back to
standby.
When water is finished boiling, the heat pipe stop working, electronic board start timing, about 2
minutes later, LCD no display, the kettle back to standby. If in 2 minutes, press 'I/O' key, LCD no
display, the kettle back to standby. If press '+' or '-' key, and don't press 'I/O' again, electronic
board start timing, about10 seconds later, LCD without any display. If press '+' or '-', and press
'I/O' again, electronic board will reset the work.
2. Insulation functions
Open the lid and full water (not more than the maximum water level 1. 8 L and cannot be less
than minimum water level 0. 8 L), then put on the lid..
Connected the power, the pot body into the power base. Now nothing appear in LCD , which
means the kettle is on standby .When the kettle on standby, only can use the'I/O', you can use
'+' and '-' buttons.
Highest heat preservation temperature can only be set at 90 ℃ : when the set temperature and
actual water temperature is higher than 90 ℃, then press ' 'button will not work; When ' '
button has been pressed, and set the water temperature as 90 ℃, and then press '+' button will
not work.
Method 1: firstly, press '+' or '-', LCD show 40℃, then press '+' or '-' button and set heat
preservation temperature, press ' ' keep warm Button, and then press 'I/O' again, LCD and the
sign under the LCD on right keep flashing. The kettle is into the preservation and began to boil
water. At this time, if not press 'I/O', LCD and and the dot under the LCD on right will not flash,
after 10 seconds, the LCD no display, kettle back to standby.
Method 2: you can press ' ' , and then press the ' + 'or ' - ' button and set preservation
temperature, and then push the 'I/O' heat preservation, LCD and the
sign under the LCD on
right keep flashing, The kettle is into the preservation and began to boil water.
In the process of boiling water, press '+' or '-', can reset the heat preservation temperature.
When set temperature is higher than the actual water temperature, continue to boil water; When
