Safety Precautions - König Electronic CMP-BLUETR20 Manual De Uso

Setup:
1. Set the Tx/Rx switch to "Rx".
2. Slide the power plug into the unit (see picture above).
3. Connect the RCA audio cable between the CMP-BLUETR20 and your Hi-Fi stereo.
4. Plug the unit into a power outlet. The blue light on the unit will blink slowly.
5. Pair your (smart) phone with the CMP-BLUETR20. Follow the instructions on your (smart) phone.
6. When the (smart) phone is paired with and connected to the CMP-BLUETR20, the blue light stops
blinking and stays on. The blue light starts blinking again when the device is disconnected.
Use as a Bluetooth® music transmitter (Tx):
Setup:
1. Set the Tx/Rx switch to "Tx".
2. Ensure that no other Bluetooth® devices are nearby.
3. Ensure that the CMP-BLUETR20 is powered off.
4. Turn on your Bluetooth® stereo headset and make sure it is in pairing mode.
5. Plug the CMP-BLUETR20 into a wall power outlet and the blue light will blink quickly. It means the Tx is in
pairing mode.
6. Ensure both pairing units are within about three meters of each other.
7. The two units should find each other and pair. After the two units are paired and connected, the blue light
indicates it by staying on.
8. The pairing pin code in Tx mode is arranged as sequence "0000", "1234", "1111" and then "8888".
SPECIAL NOTE:
When Rx is working, please don't switch to Tx mode, which will cause Tx doesn't work normally. You have to
power the CMP-BLUETR20 off firstly, then switch to Tx mode, then plug and power on and the Tx which will
work OK. On the contrary, Tx switching to Rx is the same.

Safety precautions:

Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
3