Selection Of Blades; Connecting With Cleaner - Metabo HPT CJ 18DA Manual De Instrucciones

SELECTION OF BLADES

○ Accessory blades
To ensure maximum operating effi ciency and
results, it is very important to select the appropriate
blade best suited to the type and thickness of the
material to be cut. The blade number is engraved in
the vicinity of the mounting portion of each blade.
Select appropriate blades by referring to Table 7
(page 25).
HOUSING THE HEXAGONAL BAR
WRENCH
○ It is possible to house the axiliary hexagonal bar
wrench on the base (Fig. 30).
Base
Hexagonal bar wrench
Fig. 30

CONNECTING WITH CLEANER

By connecting with cleaner (sold separately) through dust
collection adapter and adapter (sold separately), most of
dust can be collected. (Fig. 31)
Base
Dust collection
adapter
(1) Loosen the base bolt hexagonal bar wrench attached
on base. (Fig. 21)
(2) Move the base fully forward, and tighten the base bolt
again. (Fig. 21)
(3) Connect the dust collection adapter with adapter.
(Fig. 31)
(4) Connect the adapter with the nose of cleaner.
(Fig. 31)
(5) Insert dust collection adapter into the rear hole
of the base until the hook catches in the notch.
(Fig. 32)
(6) Press the hook to remove the dust collection adapter.
Hook
Rear
Base
hole
Dust collection
adapter
English
Adapter
Nose
Cleaner
Fig. 31
Notch
Adapter
Fig. 32
21