Metabo HPT CJ 18DA Manual De Instrucciones página 18

English
State of lamp
Lights ;
The battery remaining power is over
75%.
Lights ;
The battery remaining power is
50% – 75%.
Lights ;
The battery remaining power is
25% – 50%.
Lights ;
The battery remaining power is less
than 25%.
Blinks ;
The battery remaining power is
nearly empty. Recharge the battery
soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully cool
down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be
the battery so please contact your
dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and battery
characteristics, read it as a reference.
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
18
Table 6
Battery Remaining Power
CUTTING
CAUTION
In order to prevent blade dislodging, damage
or excessive wear on the plunger, please make
sure to have surface of the base plate attached
to the work piece while sawing.
1. Rectilinear cutting
When cutting on a straight line, fi rst draw a marking
gauge line and advance the saw along that line.
Using the guide (sold separately) will make it possible
to cut accurately on a straight line.
(1) Loosen the base bolt hexagonal bar wrench attached on base. (Fig. 21)
Hexagonal bar wrench
Base bolt
Base
(2) Move the base fully forward, and tighten the base bolt
again. (Fig. 21)
(3) Attach the guide by passing it through the attachment
hole on the base and tighten the M5 bolt. (Fig. 22)
M5 bolt
Fig. 21
Attachment hole
Guide
Fig. 22