Shot Of Steam - Oster GCSTCM2001 Manual De Instrucciones

Steaming
Steam ironing is only possible at high temperatures ("
on the temperature control dial (Models GCSTCM2001 & GCSTCM2002)/LED
temperature display (Model GCSTCM2003).
Be sure there is enough water in the reservoir.
Follow the instructions from the section "Using Steam Your Iron" for your iron model.
Set the steam select switch to the desired steam level position (figure 3). You are
now ready to start steam ironing. The steam will be released evenly through vents
located in the soleplate for easier ironing.
Model GCSTCM2001
SPRAY MIST
The spray mist feature is a powerful water spray mist that dampens the fabric to help
remove wrinkles from heavy fabrics and to set creases.
Press the spray mist button firmly to start the spray.
DUAL SHOT OF STEAM
This feature allows you to use shot of steam while ironing horizontally or vertically, as
the next two sections describe.

SHOT OF STEAM

The shot of steam feature provides an extra burst of steam for deep penetration of
stubborn wrinkles. The shot of steam feature can be used with dry or steam ironing
provided it has at least a 1/4 tank of water and the temperature control dial is set
within the steam band.
1. Allow the iron to heat for approximately two minutes.
2. Press the shot of steam button several times to prime the pump.
3. Press the shot of steam button another three to four times in order to clean the unit.
4. The shot of steam feature is now ready for use. The shot of steam feature can
be used continuously with just a short pause between shots. The shot of steam
feature is most effective with the Iron held in a horizontal position just above the
fabric being ironed.
Figure 3
En g lish -6
", " "), as indicated
Models GCSTCM2002
and GCSTCM2003
Figure 3