Maintenance - RIDGID RT1400M0 Manual Del Usuario

MAINTENANCE

Filter
WARNING:
To reduce the risk of injury from
accidental starting, unplug power
cord before changing or cleaning
filter.
NOTE: The Filter is made of high quality
paper designed to stop small particles of
dust. The Filter can be used for dry pick
up or small amounts of liquid. Handle the
Filter carefully when removing or installing
it. Creases in the Filter Pleats may occur
from installation but will not affect the
performance of the Filter.
Removal & Installation of the
Qwik Lock™ Filter
Filter Removal:
1. Place fingers under the two Filter Tabs.
2. While pressing down with one thumb
on the Qwik Lock™ Stud that protrudes
through the center of the Filter Plate,
lift up on the Tabs until Filter releases.
3. Slide Filter off Filter Cage.
IMPORTANT: To avoid blower wheel and
motor damage always reinstall filter before
using Vac for dry pickup.
Filter Installation:
1. Slide the Qwik Lock™ Filter over the
Filter Cage while aligning the Qwik
Lock™ Stud on the Filter Cage with
the center hole in the Qwik Lock™
Integrated Filter Plate.
2. Make sure the Rubber Gasket at the
bottom of the Qwik Lock™ Filter seats
around the base of the Filter Cage.
3. Firmly press the Qwik Lock™ Integrated
Filter Plate down around the Qwik
Lock™ Stud until it snaps into place.
SP7081 1400M0 01/19.indd 32
NOTE:# Failure to properly seat the
bottom Gasket and Integrated Filter Plate
to the Filter Cage could result in debris
bypassing the Filter.
WARNING:
Do not operate without filter cage
and float, as they prevent liquid from
entering the impeller and damaging
the motor.
Integrated Filter Plate
with Center Hole
PUSH
DOWN
PULL
UP
Powerhead
Assembly
Your Filter should be cleaned often to
maintain peak Vac performance.
32
Filter
Tabs (2)
PULL
UP
Rubber
Gasket at
Bottom of
Filter
Qwik Lock™
Stud
Filter Cage
Float
1/31/19 4:42 PM