Maintenance And Inspection - Metabo HPT C 10FCG Manual De Instrucciones

English
Saw blade
Bolt
Washer (E)
(Chamfering side)
(6) Press in the spindle lock and tighten the bolt by turning it to the left by
standard accessorie's wrench (5mm Hex. bar wrench) as indicated in
Fig. 28-b.
CAUTION:
∗ Confi rm that the spindle lock has returned to the retract position
after installing or removing the saw blade.
∗ Tighten the bolt so it does not come loose during operation.
Confi rm the bolt has been properly tightened before the power
tool is started.
2. Dismounting the saw blade
Dismount the saw blade by reversing the mounting procedures described
in paragraph 1 above.
The saw blade can easily be removed after lifting the safety cover.
CAUTION:
Never attempt to install saw blades larger than 10 in. (255mm) in
diameter.
Always install saw blades that are 9-21/32" (245mm) to 10 in.
(255mm) in diameter.
TRANSPORTATION OF THE MAIN BODY
The vice assembly could be dropped during transportation. Either remove
the assembly or slip a piece of wood between the vice to fi rmly secure it.
Drop the head and insert the locking pin (see P. 8 "Releasing the locking pin").
Turn and loosen the side handle, turn the turntable as far right as it will go, and
secure the turntable by turning the handle to the fi xed position. This will make
the main body even more compact.
When transporting the main body, carry it in your arms, holding the grip
located on the base with both hands or carry handle.
Carry Handle
Base Grip
Piece of wood to
secure the vice
14
Washer (D)
Fig. 28-c
Head
Side Handle
Vice Assembly
Fig. 29

MAINTENANCE AND INSPECTION

WARNING:
To avoid an accident or personal injury, always confirm that
the trigger switch is turned OFF and the power plug has been
disconnected from the receptacle before performing any
maintenance or inspection of this tool.
1.
Inspecting the saw blade
Always replace the saw blade immediately upon the first sign of
deterioration or damage.
A damaged saw blade can cause personal injury and a worn saw blade
can cause ineff ective operation and possible overload to the motor.
CAUTION:
Never use a dull saw blade. When a saw blade is dull, its resistance
to the hand pressure applied by the tool handle tends to increase,
making it unsafe to operate the power tool.
2. Inspecting the lever
If the M6 hexagonal head bolts (2) are loose, align the sides of the fence
and saw blade with the steel square. After adjusting the saw blade and
fence to a ninety-degree angle, tighten the lever securing hexagonal head
bolts (2).
Lever
Hex. head bolt
Fig. 30-a
Saw blade
Fence
Steel square
Fig. 30-b
3. Inspecting the carbon brushes (Fig. 31 and Fig. 32)
The carbon brushes in the motor are expendable parts.
If the carbon brushes become excessively worn, motor trouble might
occur.
Therefore, inspect the carbon brushes periodically and replace them
when they have become worn to the wear limit line as shown in Fig. 31.
Also, keep the carbon brushes clean so that they will slide smoothly within
the brush holders.
The carbon brushes can easily be removed after removal of the brush
caps (see Fig. 32) with a slotted (minus) screwdriver.
NOTE:
When replacing the carbon brushes, use only metabo HPT carbon
brushes having "43" in the last two digit of its Code No. (see Fig. 31).
If you use other carbon brushes, the electric brake will not operate.