Troubleshooting; Technical Data - Urrea SURTEK CM714A Manual De Usuario

WARNING: Never operate the power tool if
any components are loose, to prevent personal
injury.
STORAGE
Confirm that the trigger switch is turned OFF,
that the power plug has been removed from
the receptacle and that the lock-off button
has been removed and has been stored in a
secure place, after operation of the tool has
been completed. When the tool is not in use,
keep it stored in a dry place out of the reach
of children.
LUBRICATION
Lubricate the following sliding surfaces:
Rotary portion of shaft, rotary portion of vise,
rotary portion of vise-jaw & quick vise.
CLEANING
Periodically remove chips and other waste ma-
terial from the surface of the power tool with
a damp, soapy cloth. To avoid a malfunction
of the motor, protect it from contact with oil
or water.

TROUBLESHOOTING

CUT-OFF SAW WILL NOT START
Tool not plugged in. Plug in Cut-off saw.
Tripped circuit breaker or blown fuse. Reset cir-
cuit breaker or replace fuse.
Power cord damaged. Have power cord re-
placed by authorized service center.
Worn or damaged carbon brushes. Replace
carbon brushes.
CUT-OFF SAW MAKES UNSATISFACTORY CUTS
Glazed cutting wheel. Dress the wheel or re-
place with a new one.
Workpiece incorrectly clamped in vise. Secure-
ly clamp and support workpiece.
CUT-OFF WHEEL DOES NOT COME UP TO
SPEED
Extension cord too light or too long. Replace
Cord.
Low voltage from AC power source. Consult
certified electrical contractor.
E N G L I S H •
CUT-OFF SAW VIBRATES EXCESSIVELY DUR-
ING CUT
Saw not mounted securely to workbench.
Tighten all mounting hard- ware.
Damaged Cut-off wheel. Replace Cut-off
wheel.
Workpiece incorrectly clamped in vise. Clamp
workpiece securely in vise.
CUT-OFF SAW DOES NOT MAKE ACCURATE CUTS
Fence improperly adjusted. Inspect and adjust
fence.
Cut-off wheel not square to fence. Inspect and
adjust wheel.
Excessive force used to make cut. Reduce pres-
sure on cuts; let wheel do cutting.
Workpiece moving.
Clamp workpiece securely in vise.
MATERIAL MOVES DURING CUTTING
Fence slipping or workpiece incorrectly
clamped. Tighten fence.
Vise not securely clamping workpiece. Clamp
workpiece securely in vise.
Excessive force used to make cut. Reduce pres-
sure on cuts; let wheel do cutting.

TECHNICAL DATA

VOLTAGE-FREQUENCIA
NO LOAD SPEED
WHEEL CAPACITY
MAX CUTTING:
- Round hollow bar
- Square hollow bar
- Rectangle hollow bar
POWER
WEIGHT
U ser' s manual
120 V ~ 60 Hz
3 800 r/min
14" (355 mm)
4" (10 cm)
4" x 4" (10 cm x 10 cm)
5" x 4" (12,5 cm x 10 cm)
2 200 W
15 kg (33 lb)
17