Idiomas disponibles
Idiomas disponibles
Power Button
Figure C.1
Non-abrasive surface
Figure R.1
Figure R.3
Replace screws
100 mm
Specifications
4-SCREWS (M4)
MAX depth: 8.5mm
If use other screw,
check depth of hole.
Weight of LCD assembly: 4.6 kg (MAX)
Controls
OSD (On-Screen-Display) control buttons on the front of the monitor function as follows:
1. Basic function at pressing each key
Button
At No OSD
Showing OSD.
showing
At OSD showing
Go to Adjustment stage.
(Icon selection stage)
At OSD showing
Go to Icon selection stage.
(Adjustment stage)
01_English
Figure RL.1
Figure R.2
Figure TS.1
Thickness
of Bracket (Arm)
2.0 ~ 3.2 mm
Tighten all
screws
100 mm
–
SELECT
Shortcut to Bright adjust
window.
Cursor goes to left.
Adjust value decrease or
Cursor for adjust goes to
left.
2
5. Connect one end of the power cord to the monitor and the other
end to the power outlet. Place the Video Signal Cable, Audio cable
and power cord to the Cable management cover (Figure B.1).
NOTE:
Adjust position of cable that place under the Cable
management cover to avoid damage for cable or monitor.
NOTE:
Please refer to Caution section of this manual for proper
selection of power cord.
6. Turn on the monitor with the front power button and the computer
(Figure C.1).
7. No-touch Auto Adjust automatically adjusts the monitor to optimal
settings upon initial setup for most timings. For further
adjustments, use the following OSD controls:
•
Auto Adjust Contrast
•
Auto Adjust
Refer to the Controls section of this User's Manual for a full
description of these OSD controls.
NOTE:
If you have any problem, please refer to the
Troubleshooting section of this User's Manual.
Raise and Lower Monitor Screen
The monitor may be raised or lowered. To raise or lower screen, place
hands on each side of the monitor and lift or lower to the desired
height (Figure RL.1).
NOTE:
Handle with care when raising or lowering the monitor
screen.
Tilt and Swivel
Grasp both sides of the monitor screen with your hands and adjust
the tilt and swivel as desired (Figure TS.1).
NOTE:
Handle with care when tilting and swivelling the monitor screen.
Remove Monitor Stand for Mounting
To prepare the monitor for alternative mounting purposes:
1. Disconnect all cables.
2. Place monitor face down on a non-abrasive surface (Figure R.1).
3. Remove the 4 screws connecting the monitor to the stand and
remove the stand as indicated (Figure R.2). The monitor is now
ready for mounting in an alternative manner.
4. Connect the AC cord and signal cables to the back of the monitor
(Figure R.3).
5. Reverse this process to re-attach stand.
NOTE:
Use only VESA-compatible alternative mounting method.
NOTE:
Handle with care when removing monitor stand.
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm.
Please use the attached screws (4pcs) as shown in the picture when
installing. To meet the safety requirements, the monitor must be
mounted to an arm which guaranties the necessary stability under
consideration of the weight of the monitor. The LCD monitor shall only
be used with an approved arm (e.g. GS mark).
+
Shortcut to Volume adjust
window.
Cursor goes to right.
Adjust value increase or
Cursor for adjust goes to
right.
English-2
28/6/07, 5:12 PM
1<->2 / RESET
Input signal select.
Reset operation.
Mute off/on switch on
Volume adjustment window.
