Cameo ZENIT W600 Manual De Usuario página 9

---------------- Mode ----------------
Auto
Color Macro
Static
Tunable White
User Color
Color TEMPERATURE (Tunable White)
The Color temperature mode enables the light to be configured with a Color temperature of cold white to warm white (CTC), and allows bright-
ness (Dim) to be adjusted directly on the device. Select Color temperature mode as described above under "CONFIGURE STANDALONE MODE"
and confirm with ENTER. Now use UP and DOWN to select the menu item you wish to edit (observe arrow) and confirm with ENTER. The display
will now show a three-digit number field and you can use UP and DOWN to configure the desired value. Confirm by pressing ENTER. Press
MODE three times to return to the main display (Tunable White Mode).
---------------- Mode ----------------
Auto
Color Macro
Static
Tunable White
User Color
USER PRESETS (User Color)
The operating mode "User Presets" allows the overall brightness and a Color mixture of R, G, B and W to be saved directly in the device in
five individual Color presets. Select "User Color" as described above under "CONFIGURE STANDALONE MODE" and confirm with ENTER. Now
use UP and DOWN to select presets Color1 to Color5, confirm with ENTER, and select the sub-menu item you would like to edit (observe
arrow). Confirm by pressing ENTER.
The display will now show a three-digit number field and you can use UP and DOWN to configure the value between 000 and 255 as
required. Confirm again with ENTER. Once all settings have been made according to preference, press MODE four times to return to the
main display (User Color Mode).
---------------- Mode ----------------
Auto
Color Macro
Static
Tunable White
User Color
SET SLAVE MODE
Press MODE to access the device settings selection menu (--- Menu ---). Use UP and DOWN to select the menu item "Slave" (observe ar-
row) and confirm with ENTER. Connect the master and slave units (same model) with a DMX cable, and enable one of the standalone modes
on the master unit (Auto, Color Macro, Static, Tunable White, User Color). The slave unit will now follow the master unit. If there is no control
signal, the display characters will flash. Flashing stops as soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
---------------- Static ----------------
Dimmer <255>
Strobe <255>
Red <255>
Green <255>
Blue <255>
White <255>
------------- Program x -------------
Dim <100>
CTC <255>
Dim CTC
000 000
- -
100 255
------------ User Color ------------
Color1
Color2
Color3
Color4
Color5
Mode
Slave
000
-
Mode
Static
255
Mode
Tunable White
------------ Color1 ------------
Dimmer <255>
Strobe <255>
Red <255>
Green <255>
Blue <255>
White <255>
001
-
Mode
User Color
255
9