Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
Select desired ProjectPro™ nozzle:
•
For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select yellow
delicate ProjectPro™ nozzle.
•
For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways and
sidewalks, garage floors, etc., select orange general
ProjectPro™ nozzle.
•
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red max ProjectPro™
nozzle.
4.
Pull back on collar, insert selected ProjectPro™ nozzle
and release collar. Tug on ProjectPro™ nozzle to make
sure it is securely in place.
5.
For most effective cleaning, keep ProjectPro™ nozzle from
8 to 24 inches away from cleaning surface. If you get the
nozzle too close, you may damage the cleaning surface.
6.
DO NOT get closer than 6 inches when cleaning tires.
How to Use the HydroFoam™ Launcher
The quick–connect on the nozzle extension allows you to
attach the HydroFoam™ launcher. Use the HydroFoam™
launcher to apply HydroFoam™ wash or other project specific
cleaners to help break down stubborn dirt and grime on a
variety of surfaces.
Follow these instructions to attach the HydroFoam™ launcher:
1.
Engage trigger lock on spray gun.
2.
Pull back collar on quick–connect and pull current
ProjectPro™ nozzle off. Store ProjectPro™ nozzles in
holder provided on the accessory tray.
3.
Pull back on collar, insert HyrdoFoam™ launcher and
release collar. Tug on HyrdoFoam™ launcher to make
sure it is securely in place.
IMPORTANT: Also see the HydroFoam™ launcher and wash
instruction sheet for important instructions and uses.
Cleaning and Applying Detergent
Chemicals can cause bodily injury, and/or property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
To apply detergent follow these steps:
1.
Attach one of the detergent siphon hoses following
instructions Attach Detergent Siphon Hose to Pump.
IMPORTANT: Be sure engine is off and allowed to cool before
switching detergent siphoning hoses.
Contact with muffler area can result in serious
burns.
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
2.
Review ProjectPro™ nozzle and HydroFoam™ launcher
use.
3.
Prepare HydroFoam™ wash according to instructions on
the bottle or prepare detergent solution as required by job.
14
CAUTION
WARNING
Capítulos
Tabla de contenido
