Anatec MONOCOQUE S Manual Del Usuario página 25

Lubrication
Good lubrication of the propeller shaft is essential to ensure a perfect seal by preventing water entering along
the shaft into the hull.
To be effective, this must be done the evening before using the boat. This will allow the grease to congeal and
fulfill its role properly.
note that there is no need to do this before each session. As long as water does not leak back through into the
hull along the propeller shaft, it is not necessary to re-grease.
Greasing/lubrication procedure:
make sure the boat is completely dry.
Remove the cover and pull the translucent tube and to a grease bomb.
To ensure that the grease enters the transmission correctly, it is necessary to run the engine at a low speed
during the operation. When you see the grease comes out through the propeller at the rear of the boat, you can stop the operation.
The pack includes a pressurized grease bomb. only use the grease supplied with the boat.
Transporting the boat
Do not transport the bait boat with the battery inside. It may move and cause irreversible damage to internal
components of the boat.
25