Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Description
1
Main Battery
This is a lead acid battery 6V / 12 Ah positioned in the hull.
For the user manual on the loading and use of the battery, see page 24.
2
Battery housing / positioning
Depending on the size of the boat load, you are able to move the battery either further forward
or backwards in order to optimize the balance of the bait boat and load.
3
Engine
The AnATec mono hull is equipped with a ventilated motor which propels the boat.
4
Radio receiver
The main component receives the radio signal sent by the transmitter (remote control) and
transmits the information to all elements of the boat.
5
Speed controller
electronic component that controls the speed of the engine.
6
Fuse
This protects the speed control against any engine problems.
(only use 10 amp fuses (for 40R))
7
Electronic circuit board
This board houses the fuse, the radio receiver and the controller. Fixed to the boat by two
screws, it can be removed easily from the boat as well. The individual parts (fuse, receiver &
controller) can also be easily disconnected.
8
Rudder mechanism
9
Propeller shaft lubrication tube
This allows the lubrication of the propeller shaft using the supplied grease bomb.
For terms and lubrication precautions, see page 25.
10
Rudder motor
11
Cable probe for ALF fish finder (optional)
12
ALF sounder transmitter (optional)
13
Seal
14
Bin hatch activator
15
Bait tray
16
Bait tray retention clips
17
Rear Lighting (2 red Leds - high visibility)
18
Front lighting (2 white Leds - high visibility)
19
Light switch
20
LED indicator
This shows the battery charge level.
21
Main ON / OFF switch (power boat)
22
Power ON / OFF for fish finder
23
fish finder antenna fixing point
24
Carrying handle
25
Access panel
enables access to the battery compartment and the circuit board.
19
Tabla de contenido
