Dell PowerEdge 6600 Manual Del Usuario página 4

4N560ebk1.book Page 2 Monday, November 25, 2002 12:03 PM
Adding or Replacing a Microprocessor
1
2
3
4
5
6
7
8
9
10
11
12
1-2
Mircroprocessor Upgrade Installation Guide
All manuals and user guides at all-guides.com
CAUTION: Before you perform this procedure, you must turn off the system and
disconnect it from its power source.
NOTICE: See "Protecting Against Electrostatic Discharge" in the safety instructions in your
System Information document.
NOTE: For steps 1 through 5, see your Installation and Troubleshooting Guide for
details.
Open the bezel.
Turn off the system, including any attached peripherals, and disconnect the system
from the electrical outlet.
Remove the back cover.
Remove the front cover.
Raise the following components to the service position:
• Memory riser cards
• Peripheral riser card
• Fans
While grasping the microprocessor tray handles, press the release levers with your
thumbs and rotate the tray handles up until the tray is released from the front panel
(see Figure 1-1).
Slide the microprocessor tray out until the safety latches lock into place.
While pressing on the safety latches, pull the microprocessor tray straight out until the
tray clears the chassis.
Place the microprocessor tray on a flat surface.
While holding the tab on the side release lever, rotate the lever up until the cover is
released from the side of the enclosure (see Figure 1-1).
While holding the front release lever, rotate the lever up until the cover is released
from the front of the enclosure (see Figure 1-1).
Remove the cover.