Chicco activ3 Manual Del Usuario página 17

Codes 79542, 79543
Chicco KeyFit car seat can be attached to the stroller's frame using
the relative side hooks without using any additional device. To fas-
ten and release the car seat, refer to the relative product instruc-
tions.
WARNING: Always make sure the fastening system is properly
locked.
To use the car seat when travelling by car, always refer to the relative
product instructions.
HOOD
The strollers is equipped with summer/ winter hood that ensures
utmost protection against UV rays (UV50+)
49. To secure the hood, fasten the plastic clips to the locking pins
(fig. 49A) and secure the rear and side Velcro straps as shown in
fig. 49B and 49C.
WARNING: The hood must be anchored to both sides of the stroll-
er. Make sure it is secured properly.
50. To ensure further protection against the weather, the hood can
also be used in an XL configuration, open the zip located on the
side and release additional fabric to enlarge the hood (fig. 50A).
A clear double window is present on the hood's top to ensure
further contact and monitoring of your child (fig. 50B).
FABRIC BASKET
A convenient fabric basket for the parent is present on the handle's
tube, where objects can be stored for immediate use (bottle, keys,
phone, etc...). Maximum capacity: 1 kg.
51. To remove the fabric lining to wash it, release all Velcro straps
located on the part in contact with the stroller's frame (fig. 51A),
release the shaped round part of the basket from the stroller's
fame, pulling it inward (fig. 51B) and finally, remove the fabric
part from the shaped round part (Fig. 51C).
LEG COVER
The leg cover can be used in two different ways.
52. To fit the leg cover, hook the press stud buttons placed under
the seat as indicated in fig.52.
53. The leg cover can be placed over the bumper bar and fastened
within the slots as illustrated in figure (fig. 53A). Otherwise, you
can pass the leg cover's upper part under the bumper bar and
fasten it by inserting the buttons through the slots at the sides
of the backrest (fig. 53B).
RAIN COVER
The stroller may be equipped with rain cover.
54. Secure the rain cover.as shown in fig. 54. After use, dry the rain
cover outdoors (if wet) before folding and storing.
WARNING: The rain cover cannot be used on the stroller without
the hood; it may represent a suffocation hazard for the child.
WARNING: When the rain cover is on the stroller, never leave the
stroller exposed to the sun with your child inside of it, to avoid over-
heating hazards.
Important note: The images and instructions contained in this book-
let refer to a version of the stroller; some components and functions
described herein may vary according to the version you purchase.
WARRANTY
The product is guaranteed against any conformity defect in normal
conditions of use as provided for by the instructions for use.
The warranty shall not therefore apply in the case of damages
caused by improper use, wear or accidental events.
For the duration of warranty on conformity defects please refer to
the specific provisions of national laws applicable in the country of
purchase, where provided.
17