Tabla de contenido
Installation and Operation
Interpreting the Charge Pocket LEDs
The status of the charge operation is communicated by the LED located at the base of each
charging pocket.
On initial power-up, the power LED will light green and the charging LEDs will light yellow for
a few seconds.
RED
- on any charge pocket
Continuous
Flashing
RED FLASHING
- on all charge pockets
Battery charger fault or failure. Contact LXE.
GREEN
- on any charge pocket
Continuous
YELLOW
- on any charge pocket
Continuous
NO LIGHT - on a charge pocket
No battery pack installed.
Defective or damaged battery pack or charger. Refer to Troubleshooting Guide.
NO LIGHT - on all charge pockets
No battery packs installed.
No power applied to the charger.
E-EQ-MX1ISMCHGROG-C
Figure 6 MX1-IS MULTI-charger LEDs
Battery pack charging.
Battery pack fault or failure.
Battery charger timeout period expiration.
Battery pack charge complete.
Battery pack temperature is out of range.
If battery becomes too hot while charging, charging will not
resume when the battery cools down.
If the battery pack is too hot when it is inserted in the
charging pocket, the charger waits two hours for the battery
pack temperature to become within acceptable temperature
range, at which time, charging will begin.
Charging
Fault
Fault
Charged
Standby
MX1-IS MULTI-charger User's Guide
7
Tabla de contenido
