Wet/Dry Vac Assembly/Disassembly; Back View - RIDGID 1600RV Manual Del Usuario

SP6940-1 1600RV0_1_SP6940-1 1/22/15 2:28 PM Page 9

Wet/Dry Vac Assembly/Disassembly

Disassembly
1. Remove the drum from the power
base by first sliding the drum lock from
the right to the left. This lock is located
on the front of the unit just above the
power switch, between the lower portion of the drum and the power
base.
2. Lift up on the drum, using the lift
handle found on the lid of the drum.
Allowing the front of the drum to
come up first will cause the drum to
smoothly and properly disengage
from the power base.
3. With the drum sitting on the ground,
pull up on the lid latch handles found
on the left and right side of the drum.
Rotate the latches away from the lid.
4. Remove the lid from the drum
assembly and place it in a safe
location.
Note: The filter has remained in the drum
and will remain there throughout the
emptying process keeping the collected
debris confined to the drum.
All manuals and user guides at all-guides.com
Drum
Lift Handle
Lid
Drum
FORWARD
Power Base
Lid Latch Hook
Latch (2)
9
SLIDE
TO UNLOCK
Drum
Lock
Power
Base
ROTATE
BOTTOM
OF DRUM
Power Base
Drum Bottom
Hook
Rim

BACK VIEW

Lid
Drum
ROTATE DRUM
RIM FROM
UNDERNEATH
HOOK TO
UNLOCK
ROTATE
LATCHES AWAY
FROM LID TO
UNLOCK