Removing Drawers - Craftsman 31013 Manual Del Operador

• Attach the chest using two 1/4-20 screws that were used
to secure the chest to the bottom of the roll-away.
• Wrench tighten all screws.
• Replace the drawer (refer to the drawer installation instruc-
tions).
• To remove the chest, reverse the procedure.
RIseR assemBly
NOTE: When assembled, the riser should be the same
size, left to right, as the chest. Use adequate manpower
for this operation. Hardware call-out included with riser.
• Assemble the sides and the back (flange side up) to-
gether using four 8-32 x 1/4 pan head screws and four
8-32 hex nuts. Finger tighten.
• Position the riser assembly on the roll-away. Secure
using four 10-16 x 1/2 sheet metal screws. Wrench
tighten.
• Position the chest on the riser. Secure using four 10-16
x 1/2 sheet metal screws. Wrench tighten.
• Wrench tighten the risers four 8-32 x 1/4 pan head
screws and 8-32 hex nuts.
Chest
Back
opeRatIoN
RemovING DRaWeRs
• Empty the drawer.
• Fully extend the drawer
Side
Cart
Release
3
lever style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops). Pull out to remove.
tab style - Depress the release tabs on both sides (this
allows the slides to ride over the stops).
Pull out to remove.
friction style - Fully extend the drawer. Insert screwdriver
into the slot in the side and push in on the stop until it
clears the lance. Pull drawer just past lance before
releasing stop. Repeat the process for the other slide.