User Servicing Instructions; Cleaning Instructions - Kenmore 127.32217310 Manual Del Usuario

FULLY INSERT THE BLADES.

UNPLUG THIS PRODUCT FROM THE POWER SUPPLY BEFORE SERVICE.

IF THE POWER CORD IS DAMAGED, IT SHOULD BE REPLACED BY THE MANUFACTURER,
ITS AGENT LICENSED OR QUALIFIED FOR SERVICE TO AVOID A HAZARD.
SAVE THESE INSTRUCTIONS

USER SERVICING INSTRUCTIONS:

This product employs overload protection (fuse). A blown fuse indicates an overload or short-
circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse by
following the servicing instructions below (follow product marking for proper fuse rating). If the
replacement fuse also blows, a short-circuit may be present and the product should be
discarded, or call the following customer assistance number to arrange for possible product
repair: 1-886-877-1889.

Grasp plug and remove it from the receptacle or other outlet device. Do not unplug by
pulling on cord.

Select a suitable tool such as a small flat screwdriver.

Open the fuse access cover by sliding or prying it open.

Carefully remove the fuse by prying it out from one end or by turning the fuse holder over.

Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse. Gently press the new fuse into
the slot at both ends. Do not press on the glass tube.

Close the access cover until it is flush with the plug face.

Do not replace the plug. It contains safety devices (fuse, AFCI, LCDI) that should not be
removed. Discard the product if the plug is damaged.
Tips:

Do not overexert when replacing the fuse or damage may occur.

If it's hard to close the access cover, make sure the fuse is fully inserted.

CLEANING INSTRUCTIONS

WARNING: To avoid the risk of electrical shock, always make sure the product is
unplugged from the electrical outlet before disassembling, cleaning, servicing or relocating.
1. The product should be cleaned and checked on a regular basis. Make sure the fan blade
is clean at all times, to prevent the fan blade from damage and fading.
The fan can be cleaned in either of two ways:
a) Vacuum the fan blades or use a can of compressed air, or
b) Remove the front guard by removing the screws securing the guard to the fan (be
sure to use a screw-driver with a magnetic tip).
2. To clean the front guard, turn counterclockwise to loosen the screw and pull off the guard.
To place back on, match the shape of the shaft to the inside groove of the guard and push
All manuals and user guides at all-guides.com
- 3 -