Makita GA7070 Manual De Instrucciones página 11

For United States and Canada
ø45
1
ø78
2
3
ø78
4
► 1. Lock nut 2. Outer flange 78 3. Abrasive cut-off
wheel / diamond wheel 4. Inner flange 78 5. Wheel
guard for abrasive cut-off wheel / diamond wheel
Installing wire cup brush
Optional accessory
CAUTION:
Do not use brush that is damaged,
or which is out of balance. Use of damaged brush
could increase potential for injury from contact with
broken brush wires.
► 1. Wire cup brush 2. Urethane washer (included
depending on the country)
Unplug tool and place it upside down allowing easy
access to spindle.
Remove any accessories on spindle. Thread wire cup
brush onto spindle and tighten with the wrench.
Installing wire wheel brush
Optional accessory
CAUTION:
is damaged, or which is out of balance. Use of
damaged wire wheel brush could increase potential
for injury from contact with broken wires.
CAUTION:
wheel brushes, assuring diameter of wheel fits
inside guard. Wheel can shatter during use and
guard helps to reduce chances of personal injury.
5
► 1. Wire wheel brush
Remove any accessories on spindle. Thread wire wheel
brush onto spindle and tighten with the wrench.
Installing dust collecting wheel
guard
Dust collecting wheel guard for grinding
1
2
1
4
2
► 1. Lock nut 2. Cup-type diamond wheel 3. Hubbed
cup-type diamond wheel 4. Inner flange 5. Dust collecting wheel guard 6. Bearing box
WARNING:
grinding is only for use in grinding flat concrete
with a cup-type diamond wheel. Do not use it with
grinding stones or for any purpose other than
mentioned.
11 ENGLISH
Do not use wire wheel brush that
ALWAYS use guard with wire
5
6
Dust collecting wheel guard for
1
3