Sensica IPL300 Manual Del Usuario página 14

1. Make sure the treatment
window is clean, dry and
intact.
2. Charge your device
according to the
instructions in the
"Charging" Section.
3. Select the desired
treatment window and
simply snap it onto the
device by aligning the
plastic pins of the selected
window to the device
sockets and pressing the
window into place. To
remove the treatment
window, grab both sides
of the elevated dots
and firmly pull until it
disconnects from the
device.
a. Large treatment
window– suitable for fast
and easy hair removal on
large body areas, such
as legs, back and arms.
b. Precise treatment
window– suitable for
treatment of small and
delicate areas, such as
the face (area below the
cheek line) and bikini line.
14
4. Turn the device on by
pressing the ON/OFF
button. When the device
is turned on, it will be
automatically set to the
lowest energy level (1).
The device will switch to
standby mode when left
unattended for 5 minutes
or by pressing the ON/OFF
button for 3 consecutive
seconds.
5. Select the desired energy
level. Each press of the +
or – buttons will increase
or decrease the energy by
one level. The 1-6 energy
level display indicators will
light up green according to
the selected energy level
(e.g., at energy level 1, one
green light will be lit, at
energy level 2, two green
lights will be lit, etc.).
You may use the energy
recommendation button
at the start of each
treatment or manually
change energy levels.
6. Place the treatment
window on the desired
treatment area ensuring
full contact with the skin.
Apply the treatment
window firmly against your