Leggett & Platt E-95MR Guía De Operación página 7

e-95MR ReMote contRoL pRogRaMMing (2 remote controls - 1 base)
Program Two Remotes to Operate One Base - your
adjustable base will be equipped with one of the
following: (A) a DC motor with a power down box,
(B) an AC J box, (C) a DC motor without a power
down box (FIGURE 2).
a
LEARN
BUTTON
b
AC J BOX
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
c
DC MOTOR-NO
POWER DOWN
BOX
FIGURE 2: Power down box, AC J box and DC motor.
step 1
(A) DC motor with a power down box: press
the learn button on the power down box for 1
second.
(B or C) AC Jbox or DC motor without power
down box: unplug the adjustable base electrical
power cord. Wait 30 seconds, then plug the
cord back into the power source.
step 2
On the remote control, simultaneously press
and hold the flat and head massage on/off
buttons (FIGURE 3). The transmission indicator
light will flash slowly and then flash rapidly to
indicate programming mode. Continue to hold
for 5 seconds and then release the buttons.
POWER DOWN
BOX (NOT
POWER
MOUNTED TO
DOWN BOX
BASE FRAME)
LEARN
BUTTON
DC MOTOR
(MOUNTED TO
BOTTOM SIDE OF
BASE FRAME)
REMOTE REMOTE
CONTROL 1 CONTROL 2
step 3
Repeat Step 1 and Step 2 with remote control 2.
Two remote controls are now programmed to
operate one base.
FLAT
BUTTON
HEAD
MASSAGE
ON/OFF
BUTTON
FIGURE 3
note
OPERATE ONLY ONE (1) REMOTE CONTROL
AT A TIME. OPERATING TWO (2) REMOTE
CONTROLS AT THE SAME TIME WILL
MOMENTARILY BLOCK BOTH RF SIGNALS
AND PREVENT BOTH CONTROLS FROM
FUNCTIONING.
E-95MR Remote Control Operation Guide 99300791-d
TRANSMISSION
INDICATOR LIGHT
7