Leggett & Platt E-95MR Guía De Operación página 10

e-95MR ReMote contRoL pRogRaMMing (separating 2 bases)
Program Two Remotes to Operate Two Bases - your
adjustable base will be equipped with one of the following:
(A) a DC motor with a power down box, (B) an AC J box,
(C) a DC motor without a power down box (FIGURE 2).
NOTE: operate only one (1) remote control at a time.
Operating two (2) remote controls at the same time
will momentarily block both rf signals and prevent both
controls from functioning.
a
LEARN
BUTTON
b
AC J BOX
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
c
DC MOTOR-NO
POWER DOWN
BOX
FIGURE 2: Power down box, AC J box and DC motor.
step 1 (base 1)
(A) DC motor with a power down box: press the learn
button on the power down box for 1 second.
(B or C) AC Jbox or DC motor without power down
box: unplug the adjustable base electrical power
cord. Wait 30 seconds, then plug the cord back into
the power source.
step 2
On remote control 1, simultaneously press and hold
the flat and head massage on/off buttons (FIGURE
3). The transmission indicator light will flash slowly
and then flash rapidly to indicate programming
mode. Continue to hold for 5 seconds and then
release the buttons.
10
E-95MR Remote Control Operation Guide 99300791-d
POWER DOWN
BOX (NOT
POWER
MOUNTED TO
DOWN BOX
BASE FRAME)
LEARN
BUTTON
DC MOTOR
(MOUNTED TO
BOTTOM SIDE OF
BASE FRAME)
REMOTE CONTROL 1
REMOTE CONTROL 2
step 3
Repeat Step 1 and Step 2 with remote control 1.
Note: Wait 90 seconds before proceeding to Step 4.
step 4 (base 2)
(A) DC motor with a power down box: press the learn
button on the power down box for 1 second.
(B or C) AC Jbox or DC motor without power down
box: unplug the adjustable base electrical power
cord. Wait 30 seconds, then plug the cord back into
the power source.
step 5
On remote control 2, simultaneously press and hold
the flat and head massage on/off buttons (FIGURE
3). The transmission indicator light will flash slowly
and then flash rapidly to indicate programming mode.
Continue to hold for 5 seconds and then release the
buttons.
step 6
Repeat Step 4 and Step 5 with remote control 2.
Independent remote control operation is now
restored (remote control 1 operating base 1; remote
control 2 operating base 2).
FLAT
BUTTON
HEAD
MASSAGE
ON/OFF
BUTTON
FIGURE 3
BASE 1
BASE 2
TRANSMISSION
INDICATOR LIGHT