Declaration Of Conformity - Truma APC 310 Instrucciones De Uso Instrucciones De Montaje

Ocultar thumbs

página de 52

/ 52
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Troubleshooting

Error

The battery does not charge. Check all connections from

The maximum charging

current is not reached.

The master switch does not

react.

LED flashes* 1 x

Battery not connected or

defective.

LED flashes* 2 x

Unit is getting too hot.

LED flashes* 3 x

Battery temperature

too high > 50 °C.

LED flashes** 4 x

Defective wiring.

Temperature sensor or cable

defective.

LED flashes 5 x

Battery voltage of 15.4 V

and / or the max. output

current exceeded three

times.

* Reset the flash code:

takes place automatically after addressing the cause.

** Reset the flash code:

disconnect the mains voltage after addressing the cause

and disconnect battery (approx. 1 minute).

Flashing frequency:

0.2 s on, 0.2 s off, period between the flashing sequence 2 s.

If this does not solve the problem, please contact the

Truma Service.

Rectification

the device to the battery, en-

sure that they are connected

to the right terminals. Check

all fuses and the mains sup-

ply connection.

The device is too warm,

ensure better ventilation of

the device.

Disconnect the device from

the mains supply! Pull out

the mains plug and discon-

nect the battery. Reconnect

the battery after 15 seconds

and reconnect the device to

the mains supply. Press the

master switch again.

Connect battery, or replace

battery if necessary.

Ensure there is sufficient

ventilation.

Ensure there is sufficient

ventilation.

Address defect in wiring.

Replace temperature sensor.

Resetting the blink code:

Disconnect mains voltage

and disconnect battery

(approx. 1 min.).

In the event of repeated oc-

currences: Please contact

the Truma Service.