Parameter Overview - Dometic AH-Elite Control Manual Del Usuario

Programming the control unit
I
NOTE
To return to the factory default settings, reset the parameter settings
listed in chapter "Parameter overview" on page 20 manually. Then save
the settings as described above.
Restoring memorized default settings
➤ Make sure the system is in program mode (chapter "Entering program mode" on
page 18).
➤ Select P-15 (chapter "Changing parameters" on page 19).
➤ Change the parameter setting to "rSt".
➤ Press button
✓ The last memorized default settings are restored. The system exits program
mode and P-15 is set back to "nor" again.
I
NOTE
To return to the factory default settings, reset the parameter settings
listed in chapter "Parameter overview" on page 20 manually. Then save
the settings as described above.
9.5

Parameter overview

No. Description
P-1 High fan speed limit
P-2 Low fan speed limit
P-3 Reserved for future use
P-4 Temperature sensor
calibration
P-5 Reserved for future use
P-6 Reserved for future use
P-7 Reserved for future use
P-8 Reserved for future use
20
while "rSt" is displayed.
Defaults
Factory
95
50
Ambient
temp.
Range
Custom
56 – 95
4
35 – 95
30 – 75
Measurement of ambient temper-
ature can be raised or lowered by
10 °F (5.5 °C)
AH-Elite Control
5
EN