Kärcher WPC 100 FW Manual Del Usuario página 11

Operations log WPC
(A) Startup date with transfer log
Plant type: 1.024-
Startup date:
Type of raw water source:
Operating hours display [h]
Flow rate of raw water [µS/cm]
Raw water temperature [°C]
Media filter of inlet pressure during plant run-
ning [MPa]
Active carbon filter of inlet pressure during
plant running [MPa]
Inlet pressure of fine filter [MPa]
Pump pressure [MPa]
Drinking water quantity [l/h]
Yield [%]
Dosing pump flocking stroke/ frequency [%]
Dosing pump anti-scalant stroke/ frequency [%]
Remarks
Confirmation: The plant was started up and handed over in a fully functioning condition. It has been explicitly brought
to the notice of the customer that the watre produced by the plant must be checked according to the local standards
by an approved testing agency before releasing it as drinking water. Further, it has also been brought to the notice of
the customer that the operations log is to be maintained; the customer has also been informed about the risks involved
in handling chemicals and the hazards on account of interchanging the chemicals.
Place, Date, Signature (Customer)
Plant number:
Installation site:
Customer:
Raw water hardness [°dH]
pH value fo raw water [pH]
Media filter of inlet pressure during return rinsing
[MPa]
Active carbon filter of inlet pressure during return
rinsing [MPa]
Outlet pressure of fine filter [MPa]
Concentrate pressure [MPa]
Concentrate quantity [l/h]
Drinking water flow rate [µS/cm]
Dosing pump pre-chlorination stroke/ frequency
[%]
Dosing pump post-chlorination stroke/ frequency
[%]
Place, Date, Signature (Kärcher Service)
English 11