Noblex NV sight II plus Instrucciones Para El Uso página 9

START-UP AND INSTALLATION
Have the NV sight II plus installed and the gun tried out and adjusted by a
gunsmith. Attach the cover (2) only after installation.
START-UP
The sight is powered by one commercially available 3V Lithium battery CR
2032 (included in standard equipment). Operation with two CR 2016 batter-
ies is not possible.
Insert the battery into the battery cavity on the underside of the housing so
that the battery label identifying the positive pole is visible. The integrated
electronics is, however, protected against wrong polarization of the cell
through reverse insertion. To ensure reliable contact, a magnet pulls the cell
onto the gold-plated contact plate on the printed-circuit board. Keep the
contact surface clean (clean with spirit, if necessary).
BATTERY REPLACEMENT
For battery replacement, remove the complete device and turn it upside
down. Take out the exhausted battery by placing the Allen key (or a screw-
driver) in the notch located on the right-hand side as seen from the bottom.
An renewed adjustment is not necessary because of the precision pins.
POWER-SAVING MODE
The device does not contain a separate
ON/OFF switch. To operate the elec-
tronic circuit in the power-saving mode,
attach the cover. Use the thumb to slide
the cover off the NV sight II plus for use.
With your thumb first push down on
the cover's serrated section and then
forward.
You may also store the device in a light-
proof box to achieve the same power-
saving effect thus allowing operation
over a longer period.
16
INSTALLATION
Installation of the device requires the use of a separate adapter plate.
Obtain the adapter plate for the respective gun from specialist shops. Install
the device using the hexagon socket-head screws provided and the Allen
key that is also included in the equipment. The underside of the housing
contains flat bores for the accommodation of alignment pins providing
defined positioning of the device.
Please put the protective cover (2) on your NV sight II plus when cleaning
your gun. This prevents gun oil aerosols from setting on the light-emitting
diode or on the optical surfaces and makes sure that the shape of the dot
does not change.
OPERATING PROCEDURE
Elevation and windage adjustment
The sighting device contains separate controls for elevation (vertical) (3)
and windage (lateral) (4) adjustment. These are arranged on the top and the
right side of the sight.
To adjust the sight, turn the slotted screws using the provided adjusting
wrench with attached scale and the screwdriver 0.4 x 2.0.
The adjusting controls can be operated independently of each other. The
available adjustment range allows both compensation of inaccuracies in
mounting the sight and ballistic correction. The windage adjustment (4)
mechanism has limit stops at both ends.
Please note that in elevation adjustment (3) the downward stop is available
in mounted condition only.
Please note that the adjustment mechanism will be locked if you screw
down the other adjusting screw each up to the stop.
ADJUSTING ELEVATION AND WINDAGE
(Refer back view-illustration to title)
Before every adjustment of elevation (3) or windage (4), make sure to loosen
the lock of the adjustment mechanism (5) to avoid damage to it. For this,
turn the spring-loaded thrust and clamp screws on the rear side of the
sight a quarter of a turn counter-clockwise away from the limit stop using a
screwdriver 0.4 x 2.0. The adjusting controls must be smoothly movable.
17