Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Charging
Before taking the hand lamp into service for the
■
first time charge it for 6-8 hours.
Connect mains adapter to lamp.
■
Switch lamp off during charging.
■
3 An LED of the lamp flashes green during the
charging process.
3 Charging process is complete when all five LEDs
are lit green.
The following charging options are available:
• Connect USB mains adapter to a 100–240 V/
AC, 50/60 Hz socket using USB/micro USB
cable
• USB vehicle adapter (optional) to a 12 V/24 V
socket using USB/micro USB cable
• Third device with USB socket using USB/micro
USB cable
Note
Always keep the micro USB charging
socket on the lamp sealed and free of
dirt!
Battery capacity display
The residual capacity of the battery is displayed by
five green LEDs. The LEDs are located on the side of
the lamp housing.
Once only one LED is left flashing green, charge
■
the lamp.
Note
Fully charge the hand lamp before it is
stored for a longer period.
Operation
Rotary switch with dimming function
The red rotary switch is located on the rear side of
the lamp.
The COB LED 5 W is switched on by turning
■
clockwise.
Maximum luminous flux is obtained by turning
■
clockwise up to the stop.
The luminous flux can be adjusted to best suit the
■
respective work conditions by turning clockwise
or anti-clockwise.
The main light is switched off by turning an-
■
ti-clockwise up to the stop.
6
Toggle switch (on/off)
The SMD LED 3 W (flashlight function) is
■
switched on and off with the toggle switch above
the rotary switch.
Maintenance / care
Store the lamp in a dry location.
■
Do not use any technical solvents, acetone,
■
benzene, tetrachloromethane, etc.
Likewise, do not leave in contact with oils or
■
grease for long periods.
Damaged charging cables and mains adapters
■
must be replaced immediately.
Disclaimer
The information in these operating instructions can
be changed without prior notice. Würth does not
accept any liability for direct, indirect, accidental
or other damage or consequential damage which
result from the usage or the application of the infor-
mation in these operating instructions.
Environmental instructions
Do not dispose of this device with
household waste. Dispose of the
device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid
regulations.
In case of doubt, contact your waste disposal facil-
ity. Dispose of all packaging in an environmentally
compatible manner. Do not dispose of batteries in
household waste. Hand in used batteries at your
supplier or at a battery collecting point.
Subject to technical changes without prior notice.
We accept no liability for printing errors.
Adolf Würth GmbH & Co. KG, Abt. PCH
Künzelsau: 19/03/2018
Tabla de contenido
