Aventics PROFIBUS DP Instrucciones De Servicio página 57

During assembly
During commissioning
During operation
During cleaning
AVENTICS | PROFIBUS DP | R412009414-BDL-001-AE
W
The warranty only applies to the delivered configuration.
The warranty will not apply if the system is incorrectly
assembled or manipulated.
W
Make sure the relevant system component is not under
pressure or voltage before assembly or disassembly.
Ensure that the system is prevented from power restoration
during assembly work.
W
Ground the modules and the valve system. Observe the
following standards when installing the system:
– DIN EN 50178, classification VDE 0160
– VDE 0100.
W
Installation may only be performed in a voltage-free and
pressure-free state and only by a qualified technician. In
order to avoid accidents caused by dangerous movements
of the actuators, electrical commissioning is to be carried
out only in a pressure-free state.
W
Do not put the system into operation before it is completely
assembled as well as correctly wired and configured, and
after it has been tested.
W
The device is subject to the restrictions of the IP65
protection class. Before commissioning, make sure that all
the connection seals and plugs are leaktight to prevent
fluids or foreign bodies from penetrating the device..
W
Make sure that there is a sufficient exchange of air or
enough cooling if your valve system has any of the following:
– Complete equipment
– Continuously loaded solenoid valves
W
Never use solvents or aggressive detergents. Only clean the
device using a slightly damp cloth. Only use water to do this
and, if necessary, a mild detergent.
57
For your safety