Operating Instructions; Product Description; Product Usage - Kunft KWH4209 Manual De Instrucciones

2. OPERATING INSTRUCTIONS

2.1. Product Description

Remote Control Instruction Panel
Week day
Lock
Temperature
Time
Program button
"+" button
Button instructions
1. "
" button: to turn the appliance ON or OFF
2. "+" button: to increase the temperature and timer (hold "+" into the
cycle of weekly timer)
3. "-" button: to increase the temperature and timer (hold "-" to confirm
the weekly timer)
4. "mode button": to change the mode to I, II, ECO (hold the Mode
button to switch the window sensor off or on)
5. "PROG" button: to set the week day and timer
6. "Lock" button: hold the button to lock and unlock the remote control.
Heat
Clock
Mode
ECO mode
Program
'Window open'
sensor
Mode button
Lock button
Power button
"-" button
10
wall mounted heater

2.2. Product usage

Features
• PTC ceramic heater elements, high efficiency heating, quick heating,
noiseless, odour-free, non-polluting, no flame and environmentally
harmless (it will not kill the oxygen).
• Two heating levels so you can set the temperature according to
your preferences.
• There is temperature fuse due to the danger of overheating and
a motor overheat protection. It automatically turns off when the
air outlet is blocked and turns on again when the blockages are
cleared away.
• Natural / hot air selection. You may close the heating element in the
summer so that the heater can blow cool air.
• Safety thermostat for overheat protection.
Installation
• Drill two holes on the wall about 1.8 m from the ground. The
diameter of the hole should be wide enough to contain the inflated
plastic pipe, which has a diameter of 6 mm.
• After tucking in the inflated plastic pipe, fix the hook on the pipe
with a screw. Please make sure the hook is fully inserted, as below
picture.
Heater instructions
• Remove all packaging and place the heater in your desired location.
• Unwind the power cord and plug it into the power outlet.
• Press the " " button; the LCD display will turn on and the heater
will switch on; press again the button again and the heater will
switch off.
• Press the MODE button: to change the mode to I, II, ECO; I for
low power, II for high power, ECO to keep the room temperature at
18ºC. When the temperature sensor reaches the room temperature
EN
KWH4209
11