LD Systems VIBZ 8 Manual De Usuario página 8

18
DFX PEAK LED
Once the red Peak LED lights up, the input of the internal effects device is operating at the distortion limit. Adjust the Effect Send controller
of the input channels (N 10) so that the peak LED only lights up briefly when signal peaks occur.
19
DFX MUTE
In order to mute the internal effects device, briefly press the DFX Mute button once, and again to turn mute off. If Mute is active, the DFX
Peak LED lights up continuously.
20
EFFECTS LIST
List of effects programs for the internal effects device.
21
DFX TO MAIN
Volume controller for adding the effects signal of the internal effects device to the sum channel MAIN MIX. Press the Fader button upwards
to increase the volume of the effect and downwards to decrease it.
22
DFX MUTE FOOTSWITCH
6.3 mm jack socket for connecting a foot switch (pedal) to remotely activate and disable the mute function of the internal effects device
(footswitch optional).
23
ST RETURN L / R
Unbalanced stereo line input with 6.3 mm jack sockets for connecting an external effects device (left input = mono), or another source
device with a line level. Use the AUX SEND jack socket in order to activate an external effects device. When using the AUX SEND jack socket,
the internal effects device is automatically bypassed, and is therefore not usable.
24
ST RETURN
Volume controller for the stereo line input ST RETURN (N 23). The ST RETURN signal is mixed directly into the sum channel MAIN MIX.
Turning the dial to the right increases the volume and turning it to the left decreases it.
25
PHONES
Headphone connection with 6.3 mm stereo jack. Output of the sum channel signal MAIN MIX. The volume can be adjusted via the PHONES /
CTRL volume controller (N 27) and is independent of the volume of the MAIN MIX level controller. Use headphones with a minimum imped-
ance of 30 ohms and make sure that the volume stays at a pleasant level, in order to avoid hearing damage caused by loud noise.
26
CTRL OUT L / R
Unbalanced stereo line output with 6.3 mm jack sockets to connect active monitors etc... Output of the sum channel signal MAIN MIX. The
volume can be adjusted via the PHONES / CTRL volume controller (N 27) and is independent of the volume of the MAIN MIX level controller.
27
PHONES / CTRL
Volume controller for the stereo line output CTRL (N 26) and the headphone output PHONES (N 25). When using headphones, make sure
that the volume stays at a pleasant level, in order to avoid hearing damage caused by loud noise.
28
2 TK IN
Unbalanced stereo line input with RCA sockets for connecting an external audio source with line level (e.g. MP3 player).
29
2 TK IN LEVEL
Volume controller for the stereo line input 2 TK IN (N 28). Turning the dial to the right increases the volume and turning it to the left decreases it.
30
2 TK IN TO MAIN / TO CTRL
This switch allows to route the incoming signal of the stereo line input 2 TK IN either to the stereo line output MAIN MIX OUT (not pressed
down = TO MAIN), or to the stereo line output CTRL OUT and headphone output PHONES (pressed down = TO CTRL).
8