Securing The Chimney; Installing The Lid Handles; Securing The Cart Bars - Pit Boss Pro PB1100PSC2 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

9. SECURING THE CHIMNEY

Parts Required:
1
x
Chimney Cap (#4)
1
x
Chimney Stack (#5)
3
x
Screw (#A)
3
x
Locking Washer (#C)
3
x
Washer (#B)
3
x
Nut (#I)
Installation:
Locate the chimney opening on the backside of the gas barrel. From
the inside of the gas barrel, insert the Chimney Stack through the
opening. Insert a washer, locking washer, and screw into each hole
from the outside of the gas barrel, but fasten only half-way into the
the nut from the inside. Once all three screws are installed, fasten the
screws completely.
Next, twist the chimney cap onto the top of the chimney stack.
NOTE: Adjust the chimney cap to affect the airflow inside the main
grill. If cooking at low temperature, keep the cap more open. Ensure
the chimney cap allows for air to escape.

10. INSTALLING THE LID HANDLES

Parts Required:
4
x
Lid Handle Bezel (#28)
2
x
Lid Handle (#29)
Installation:
Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a bezel on
the screw, then hand-tighten the screw (from the inside) into the lid
handle. Repeat same installation for other end of lid handle.

11. SECURING THE CART BARS

Parts Required:
2
x
Cart Bar A (#40)
2
x
Cart Bar B (#41)
Installation:
Secure the cart bar A and cart bar B to each support leg using the pre-
installed screws, locking washers, and washers.
9
4
A
C
B
5
I
I
10
29
28
28
11
40
41
29
13
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

919309258283049255024

Tabla de contenido