Assembly Floor Fastening Heavy Duty - Extremis PICNIK Instrucciones De Montaje

ASSEMBLY FLOOR FASTENING HEAVY DUTY

WHAT YOU NEED
2 people
hex key no. 5
+/- 30 min.
1. Remove the protection caps of the
fastening screws of the 4 feet indicated
on the above drawing and loosen these
screws with a 5 mm Allen wrench.
4. Replace them by the 4 new feet. The
side with the holes should always be
facing inwards.
7. Now mark the spots on the ground, as shown on page 16, where you want to anchor the table. Put the Picnik table aside and drill
holes at the indicated spots. Use the fixing media most suited to the type of ground on which you intend to install the Picnik table.
To anchor the Picnik table to the ground,
4 of the 6 already mounted stainless steel
feet must be removed and replaced by
the 4 stainless steel feet of the PFLHD04
ground anchor kit.
2. Remove the feet.
5. Fasten them by means of countersunk
bolts M6 x 25.
3. Insert the spacers in the 4 holes used
for anchoring the table to the ground.
6. Fix these with nuts M6.
english 5