What You Need; Assembly Marina Bench - Extremis MARINA Manual Del Usuario

ASSEMBLY MARINA BENCH

WHAT YOU NEED

min. 1 person
open-end spanner no. 10 - 17
hexagon socket wrench no. 3 - 4
+/- 30 min.
2. Now screw the adjustable feet into the legs. Repeat step 1
through 2 for each table leg assembly and put them aside.
4. Insert the benc end piece with the lips into the slots from left
to right. Fasten them using 3 M5 x 12 countersunk bolts.
Repeat this operation on the other side, this time from right
to left.
4 assembly marina bench + maintenance
All manuals and user guides at all-guides.com
1. Insert the table legs into the bench connection, aligning the 3 holes, and use
12 M6 x 16 hexagon socket bolts and 12 lock nuts to fasten them. First push all the
bolt shafts through the holes and make sure that the bolts are on the outside. Then
thread the nuts onto the shafts of the bolts and tighten them firmly.
3. Put the 3 bench profiles on the floor, with the slots facing
5. Now fasten the table leg assembly with the bench connection
upwards, and make sure that the crosses are facing the same
way. Insert a spacer between each profile at +/- 40 cm from
the end.
to the profiles, each time at the intended place, using
6 M6 x 20 hexagon socket bolts + reinforcement profiles (also
use 6 M6 x 20 hexagon socket bolts). Remove the spacers.