Trouble Shooting - MADER 65575 Manual Del Usuario

TROUBLE SHOOTING

PROBLEM
Fails to split logs
The log pusher moves
jerkily, taking unfamiliar
noise or vibrating a lot
Oil leaks around
cylinder ram or from
other points.
ATTENTION: ALL REPAIR WORK MUST BE DONE BY A SPECIALIST FOR THIS PRODUCT.
PROBABLE CAUSE
Log is improperly positioned
The sizes or hardness of the log
exceeds the capacity of the
machine
Wedge cutting edge is blunt
Oil leaks
Unauthorized adjustment was
made on Max. Pressure Limiting
Screw. Lower max pressure
rating was set.
Lack of hydraulic oil and
excessive air in the hydraulic
system.
Air sealed in hydraulic system
while operating.
Bleed Screw is not tightened
before moving the log splitter.
Oil Drain Bolt with Dipstick is not
tight.
Hydraulic Control
Assembly and / or seal(s) worn
REMEDY SUGGESTED
Refer to "Log Splitter Operation" section for
perfect log loading.
Reduce the log sizes before splitting it on the
log splitter
Refer to "Sharpening Wedge "section to
sharpen the cutting edge.
Locate leak(s) and contact the dealer
Contact the dealer.
Check oil level for possible oil refilling.
Contact the dealer.
Loosen Bleed Screw by some rotations
before operating the log splitter
Tighten the Bleed Screw up before moving
the log splitter.
Tighten the Oil Drain Bolt with Dipstick.
Valve
Contact the dealer