MADER 65575 Manual Del Usuario página 51

ASSEMBLY
Transport Handle
Mount the transport handle to the U bracket with two
M8×20 screws.
Log Tray
1. Mount the guard bottom plate F to the right body cover and secure with two M6x16
socket head cap screws and washers.
Mount the open end of support strut 2F with the right body cover and secure with M6x16
socket head cap screw and washer.
Connect the upper end of support strut 2F to the guard bottom plate F and secure with
cross recessed pan head screw M6x12 and locknut M6. Tighten all the screws and nuts.
2. Align the two mounting holes of the log tray 1F to the holes on rear side of the splitter.
Insert one bolt M8×16 and flat washer 8 into the mounting hole on left side and the other
socket head cap screw M6×16 and flat washer 6 on right side and securely tighten both.
Loosen the bolt on the bottom side of the right body cover, insert the open end of support
strut 1F onto the bolt and then tighten the bolt. Connect the upper end of support strut 1F to
the log tray 1F with cross recessed pan head screw M6×12 and locknut M6 and then
tighten it.
3. Align the two mounting holes of the log tray 2F to the holes on front side of the splitter.
Insert one bolt M8x16 and flat washer 8 into the mounting hole on right side and the other
socket head cap screw M6x16 and flat washer 6 on left side and securely tighten both.
Loosen the bolt on the bottom of the left body cover, insert the open end of support strut 1F
onto the bolt and then tighten the bolt. Connect the upper end of support strut 1F to the log
tray 2F with cross recessed pan head screw M6x12 and locknut M6 and then tighten it.
4. Connect log tray 1F and log tray 2F with two M6×12 socket head cap screws and
locknuts.