DJI ZENMUSE X9 Manual Del Usuario página 7

• Make sure the focus motor gear can rotate smoothly after attaching it to the gear strip. Otherwise, calibration and the
performance of the focus motor may be affected.
• Trim the gear strip to the required length while leaving enough for adjustments if needed.
• To loosen the gear strip, push the gear strip outward while holding the belt holder tightly. DO NOT pull out the gear
strip forcibly. Otherwise, the gear strip may be damaged.
• DO NOT bend the gear strip excessively. Otherwise, the gear strip may break.
Installing the Focus Motor
Install the X9 focus motor holder (hereinafter referred to as
the "holder") onto the bottom of the gimbal camera.
Insert the focus motor into the holder. Loosen the gear lock
knob, move the gear to the same height as the gear strip
before tightening the gear lock knob, and adjust the gear until
it locks into the gear strip. Close the holder buckle.
Open the holder buckle.
Connect the LiDAR range finder/focus motor
cable to the power port of the gimbal.
5