Operation Instructions; Maintenance - Urrea EHT10 Manual De Usuario

WARNING: The wiring must comply with
local code. Have a certified electrician make
the electrical hook-up to the power unit. Pro-
tect each circuit with time delay fuse or circuit
breaker 208V-230V Single Phase 60Hz 30A.
Motor cannot run on 50Hz without a physical
change to motor.
ATTENTION: IF 380V POWER UNIT APPLIES,
PLEASE ADJUST AND USE RELATIVE TWIST
LOCK AND TIME DELAY FUSE OR CIRCUIT
BREAKER ACCORDINGLY.
STEP 21: Do not place any vehicle on the lift
at this time. Cycle the lift up and down several
times to insure latches click together and all air
is removed from the system. To lower the lift,
both latch releases must be manually released.
Latches will automatically reset once the lift as-
cends approximately 17" from base. If latches
click out of sync, tighten the cable on the one
that clicks first.

OPERATION INSTRUCTIONS

RAISE THE LIFT
Press button on power unit. The latch mecha-
nism will 'trip over' when the lift raises and
drops into each latch stop. But to lock the lift
you must press the lower level to relieve the
hydraulic pressure and let the latch set tight in
a lock position.
Always lock the lift before going under the
vehicle. Never allow anyone to go under the
lift when raising or lowering. Read the safety
procedures in the manual.
NOTE: It is normal for an empty lift. to lower
slowly. It may be necessary to add weight.
LOWER THE LIFT
1. Raise the lift until the latch clears.
2. Pull both latch releases.
WARNING: ALWAYS RELEASE BOTH SIDES.
3. Press the lever at the power unit to lower
the lift.
SAFETY PROCEDURES
Never allow an unauthorized person to oper-
ate lift. Thoroughly train new employees in the
use and care of the lift.
CAUTION: The power unit operates at high
pressure.
Remove passengers before raising vehicle.
E N G L I S H •
Prohibit unauthorized people from being in
shop area while lift is in use.
Total lift capacity is 10 000lbs with 2500lbs per
arm pad.
Prior to lifting vehicle, walk around the lift and
check for any objects that might interfere with
the operation of; lift, safety latches, tools, air
hoses or shop equipment.
When approaching the lift with a vehicle, cen-
ter the vehicle between the columns so that
the tires will clear the swing arms easily. Slowly
drive the vehicle up between the posts.
Have someone outside the vehicle guide the
driver.
Always lift vehicle using all four arms.
Never use lift to raise one end or one side of
the vehicle.
Raise vehicles about 3' and check stability by
rocking.
Prior to lowering vehicle, walk around the lift
and check for any objects that might interfere
with the operation of lift, safety latches, tools,
air hoses or shop equipment. Swing the arms
out of the path and slowly drive the vehicle
out. Have someone outside the vehicle guide
the driver.
ALWAYS LOCK THE LIFT BEFORE GOING UNDER
THE VEHICLE.
NEVER ALLOW ANYONE TO GO UNDER THE
LIFT WHEN RAISING OR LOWERING.

MAINTENANCE

MAINTENANCE SCHEDULE
The following periodic maintenance is the sug-
gested minimum requirements and mininium
intervals of accumulated hours or monthly pe-
riod, which ever comes sooner. If you hear a
noise or see any indication of impending fail-
ure, cease operation immediately and inspect,
correct and/or replace parts as required.
IT IS IMPORTANT TO INSPECT LIFTING EQUIP-
MENT AT THE START OF EVER Y SHIFT. THESE
AND OTHER PERIODIC INSPECTIONS ARE THE
RESPONSIBILITY OF THE USER.
DAILY PRE-OPERATlON CHECK (8 HOURS)
The user should perform daily check.
ATTENTION: Daily check of safety latch sys-
tem is very important and the discovery of de-
vice failure before needed could save you from
U se r 's m a nu a l
17