CRC SmartWasher SW-23 Manual De Instrucciones página 37

If you are using the FL-4 OzzyMat
make sure you are peeling away the individual layers on
a weekly basis. Change the entire OzzyMat
week OR every month. Make sure to remove any excess
grease, dirt and debris from dirty parts prior to washing.
Does the OzzyMat
to pool up in the sink?
If the fluid is backing up in the sink and not draining
through the OzzyMat
®
evaporation and the low fluid light may come on
prematurely because the fluid is in the sink, not in
the base.
How many operators and how many hours a
day are you using the SmartWasher
This will help you determine if they have high, normal
or low usage. If you have higher than normal usage, you
will have higher fluid usage.
SmartWasher
BIOREMEDIATING parts washing system
USER INSTRUCTION MANUAL
then you need to
®
®
clog up and cause the fluid
®
properly, there will be increased
?
®
ORIGINAL INSTRUCTIONS
When did you notice the change in usage?
If fluid usage has been fine for a period of time and usage
on the 4th has just recently increased, check to see if anything has
changed recently. (New employees, more employees,
more parts being cleaned, longer hours of use, etc.)
Are operators squeezing the excessive fluid
out of the OzzyMat
installing a new OzzyMat
When changing out the old OzzyMat
any excessive fluid.
What if the fluid has discoloration or gives
odour?
OzzyJuice
oils or greases removed from dirty parts. This will not
affect its cleaning power. If the fluid should develop a
strong odour, it may be contaminated and you should
call local CRC distributor.
into the sink after
®
?
®
may become dark in colour due to dyes in
®
®
, squeeze out
®
page 37 of 720