Safety Instructions For Batteries - REMS Power-Press SE Instrucciones De Servicio

g
b) Do not use the power tool if the switch does not turn it on and off. Any power
tool that cannot be controlled with the switch is dangerous and must be repaired.
storing power tools. Such preventive safety measures reduce the risk of starting
the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons
tool. Power tools are dangerous in the hands of untrained users.
accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
Use of the power tool for operations different from those intended
could result in a hazardous situation.
5) Battery tool use and care
with another battery pack.
irritation or burns.
6) Service
This will ensure that the safety of the power tool
is maintained.
Safety instructions for presses
WARNING
Read all safety warnings and all instructions. Failure to follow the warnings and
Save all warnings and instructions for future reference.
a very high pressing force. It is safer to hold the tool with both hands. Therefore
be very careful. Keep children and bystanders away while operating the power
tool.
Never operate radial presses with the tong retaining bolt unlocked (2). There
pipe axis. If the radial press is positioned askew to the pipe axis, its high drive
force will pull it to a right angle to the pipe axis. This could crush hands or other
serious injuries.
pressing ring with adapter tongs. Do not start the pressing process except to
drive unit, pressing tongs, Mini pressing tongs, pressing ring and adapter tongs
will be needlessly stressed.
whether these are suitable for the REMS radial presses. Pressing tongs,
pressing rings with adapter tongs of other makes can be used in REMS Power-
Press SE, REMS Power-Press, REMS Power-Press ACC, REMS Akku-Press
and REMS Akku-Press ACC if they are designed for the necessary thrust force
the end of their life or when overloaded. It is recommended to only use pressing
tongs and pressing rings with adapter tongs which are designed with a safety
manuals and safety instructions of the respective manufacturer/supplier of the
pressing tongs, pressing rings with adapter tongs and the installation and assembly
Pressing tongs, pressing rings with adapter tongs (pressing jaws, pressing slings
with adapter jaws) from other manufacturers are not approved by REMS for
REMS Power-Press E.
Only operate the axial press with pressing heads fully inserted. Failure to
Many
A charger
Use of any
Shorting the battery
Liquid ejected from the battery may cause
The power tool produces
There
Also read and observe the instruction
Always screw expanding heads as far as they will go onto the expander.
tongs, Mini pressing tongs, pressing rings, adapter tongs, pressing heads and
attempt to repair damaged pressing tongs, Mini pressing tongs, pressing rings,
adapter tongs, pressing heads and expanding heads. Failure to do so could lead
heads and expanding heads. There is a risk of injury.
service workshop in case of damage.
Only allow trained persons to use the power tool. Apprentices may only use
and when they are supervised by a trained operative.
These power tools are not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge unless they have been given supervision or instruction concerning
the use of the power tool by a person responsible for their safety. Children must
be supervises to ensure that they do not play with the power tool.

Safety instructions for batteries

WARNING
Read all safety warnings and all instructions. Failure to follow the warnings and
Save all warnings and instructions for future reference.
Only use the battery in REMS power tools and in the REMS cordless LED
Only then is the battery safe from dangerous overloading.
plate.
batteries.
Only recharge REMS batteries in the REMS rapid charger. There is a risk of
Charge the battery to full capacity in the REMS rapid charger before using
Batteries are delivered partly charged.
There is a risk of bending the battery contacts and damaging the battery.
Do not use the battery in areas where there is a risk of explosion and in the
to or improper use of the battery can cause fumes to escape. The fumes can
irritate the respiratory tracts. Let in fresh air and consult a doctor in case of
symptoms.
the eyes.
Observe the safety instructions on the battery and the rapid charger.
Protect the battery contacts against short-circuiting, e.g. with a cap.
defective batteries over to an authorised REMS contract service workshop or a
recognised disposal company.
WARNING Danger with a medium degree of risk which could result in
death or severe injury (irreversible) if not heeded.
CAUTION Danger with a low degree of risk which could result in minor
injury (reversible) if not heeded.
Material damage, no safety note! No danger of injury.
Read the opera ing manual before star ing
Use eye protection
Use ear protection
g
Damaged pressing
There is
There is a risk of explosion
Damage
-
Hand the